HONDA PRELUDE - BB1/BB4

PRODUCT LIST

Product Material PART # MSRP(yen) REMARKS
FRONT LIP SPOILERFRP8001W-H003JPY32,400 
AERO BONNET HOODFRP8006W-H003JPY93,960Bonnet pins are contained.
REAR SPOILER (GT-WING)FRP8004W-H003discontinued

FRONT LIP SPOILER

It leaves a normal good design and has a good figure. This lip-spoiler has the form low and projected to the front. It makes the rectification effect of a front part.

SPECIFICATIONS
Vehicle HONDA PRELUDE BB1/BB4
Material FRP(White gel coat)
Weight 1.6kg
Width 1750mm
Depth 110mm
Paint No
AccessoriesNo
  • * Weight and dimensions are the reference values. They may be different from the things.
  • * Entrust the professional shop whose reliability is high with the installation of this product.

AERO BONNET HOOD

A runnig-wind is discharged efficiently and engine room is cooled efficiently because this bonnet has two large air duct at the central of front. This bonnet is made from FRP material so it is very light. It can prevent vibration of bonnet at the time of a high-speed-running because it is the three hold type which uses both two bonnet pin and normal holder.

* There are no hood pins in the photograph because the car is development car. But the pins are contained.

SPECIFICATIONS
Vehicle HONDA PRELUDE BB1/BB4
Material FRP(Black gel coat)
Weight 8.5kg
Width 1470mm
Depth 1300mm
Paint No
AccessoriesBonnet hood pins
  • * Weight and dimensions are the reference values. They may be different from the things.
  • * Entrust the professional shop whose reliability is high with the installation of this product.
  • * Be sure to install hood pins for the safety.
  • * The bonnet pin holes are not opened. Make holes in the position where your car fit it.

REAR SPOILER (GT-WING)

* This product was discontinued.

The wing position change into high position so that can get more down-force. It can change of two position (every 4 degree). Stay is made from aluminum material so it is very light and strong. It is expressed the beauty of aluminum material.

SPECIFICATIONS
Vehicle HONDA PRELUDE BB1/BB4
WING PART
Material FRP(White gel coat)
Weight 3.3kg
Width 1300mm
Depth 280mm
Paint No
STAY PART
Material Aluminum
Weight 2.0kg
Height 210mm
Paint No
AccessoriesNo
Note Body processing required.
  • * Weight and dimensions are the reference values. They may be different from the things.
  • * Entrust the professional shop whose reliability is high with the installation of this product.